On this page
Short answer: The Clean module uses a model that recognizes the voice and reduces everything else: background noise and the reverb of the room. You set how much noise and how much reverb to remove, check the result with Delta, and fine-tune single frequency areas in the spectrogram. It runs locally on your computer. Clean is part of VoiceAssist Advanced.
Fans, traffic, hum and a reflective room are the most common reasons a voice recording sounds amateur. Classic noise reduction needs a noise profile and struggles with changing noise and with reverb. Clean works on the voice itself instead.
Which Settings Does Clean Have?
- Noise and Reverb: two separate amounts, so you can remove a lot of noise but keep some room, or the other way around.
- Delta: plays only what is being removed. If you hear parts of the voice in the Delta, you are going too far.
- Recover Highs: restores high frequencies up to a frequency you set, for recordings that sound dull or were made with limited bandwidth.
- Spectral editing: in the spectrogram you click and drag over an area to boost or cut it, for example a single noise burst.
How Far Should You Go?
Turn Noise and Reverb up until the background disappears, then back off a little and listen with Delta. A little room tone usually sounds more natural than total silence, especially in dialogue that will be edited against other takes.
What Hardware Does Clean Need?
On Windows, VoiceAssist Advanced needs a dedicated NVIDIA or AMD graphics card for the Clean model, with 6 GB VRAM recommended. On a Mac it runs on Apple Silicon. The free trial is the easiest way to check your system.
More on noise in general: How To Remove Background Noise and How To Reduce Room Echo.
Hear Clean on your own recordingsVoiceAssist Advanced free for 14 days, no credit card.
Try VoiceAssist Free
How To Remove Background Noise
How To Reduce Room Echo
What Is ARA?












